BEVEL SIDING

Hardwood and Softwood Bevel Siding

Bevel siding is manufactured by running rough lumber or S4S blanks to a bevel bead profile - this profile, which contains offset notches on both edges, is then re-sawn through a band saw in order to make two pieces of bevel siding from one piece of lumber. Typically, we run bevel blanks in 1x6 but both 1x8 and 1x4, and occasionally 1x10, are typical sizes. The band saw leaves a rough texture on one face of the material whereas the other side of the piece of siding is surfaced smooth.

In terms of value, bevel siding is one of the most efficient ways to make a high quality siding product. In terms of surface measure, bevel siding almost doubles the amount of SF coverage when compared to a T&G, Shiplap or straight S4S pattern. Installation of bevel siding requires careful use of fasteners so as not to split the very thin material. Pre-drilling and face nailing is generally the best technique to ensure that damage during installation is kept to a minimum. It is always recommended to use a house wrap with some air flow behind the bevel siding - many house wrap manufacturers produce a dimpled product which keeps air flowing behind the wood and promotes superior moisture management.